// BUILT INTO IRONLEDGER //

Starting Strength program.

Starting Strength is Mark Rippetoe’s program for new lifters: two barbell workouts that alternate three days a week, with the squat every session and more weight on the bar each time. It runs until session-to-session progress stops. IronLedger has the first stage built in, in two versions.

Three days a weekTwo alternating workoutsWeight added every sessionBuilt into IronLedger

Updated

// THE PROGRAM //

Two workouts, three days.

Workouts A and B alternate on Monday, Wednesday and Friday, so one week runs A, B, A and the next B, A, B, with two days off at the end of each week.

How workouts A and B alternate
Day 1Day 2Day 3
Week 1ABA
Week 2BAB

Heavy fives

The main lifts are trained for sets of 5. A 2017 meta-analysis found heavy loads build more one-rep-max strength than light ones, which is what a novice program is after.

More weight every session

The book has you add weight to the work sets every workout, for as long as that keeps working, rather than every week.

Built on a few lifts

The squat, press, bench press, deadlift and power clean, with a few assistance exercises such as chin-ups. The squat is in every session.

// FROM THE BOOK //

The program in stages.

As the third edition sets it out. The squat is in every workout, and the order is always squat, then the upper-body lift, then the pull.

Starting Strength’s novice stages
StageWorkout AWorkout B
The first couple of weeksSquat, press, deadliftSquat, bench press, deadlift
ThenSquat, press, deadliftSquat, bench press, power clean
Two or three weeks laterSquat, press, deadliftSquat, bench press, power clean, then 3 sets of chin-ups
Work sets and weight jumps in the book
LiftWork setsWeight added each workout
Squat3 × 510 lb a workout for most men for 2 to 3 weeks, then 5 lb
Bench press3 × 55 lb, then smaller jumps
Press3 × 55 lb, then smaller jumps
Deadlift1 × 515 lb a workout for most men for a couple of weeks, then 5 lb
Power clean5 × 3About 5 lb

Warm up from the empty bar in even jumps, usually three to five sets, keeping the last one light enough not to tire you for the work sets. Every rep of every work set has to be done before the weight goes up. If recovery becomes a problem, the book swaps some of the pulling for back extensions and drops the deadlift to every fifth workout, alternating with power cleans. Younger, older and lighter lifters and most women take smaller jumps from the start.

// THE WORKOUTS //

Workouts A and B.

As IronLedger runs them: the book’s first stage, before power cleans and chin-ups come in. The last column is the step the set-up version adds every workout: 2.5 kg is about 5.5 lb and 5 kg about 11 lb.

Workout A
ExerciseSets × repsAdded each session
Squat3 × 52.5 kg
Bench press3 × 52.5 kg
Deadlift1 × 55 kg
Workout B
ExerciseSets × repsAdded each session
Squat3 × 52.5 kg
Press3 × 52.5 kg
Deadlift1 × 55 kg

Once the working weight is well above the empty bar, the app lists warm-up sets first: the bar for 5, then about 40% for 5, 60% for 3 and 80% for 2, close to the book’s own example. Each working set’s notes say to rest 3 to 5 minutes and to add weight next session only if you completed every rep.

// WHEN IT STOPS //

When the bar stops moving.

Every novice reaches a point where adding weight each session no longer works.

A missed rep on a bad night is not a stall; repeated misses at the same weight are. Our guide to when linear progression stops working covers how to tell the difference. The book’s own rule for the squat: when you miss the last rep or two, back off 5 lb and carry on with 5 lb jumps. When even small jumps stop working, the next step is a program that adds weight weekly, such as the Texas Method, or 5/3/1, which we compare with Starting Strength here.

// IN IRONLEDGER //

Two ways to run it.

Both are on the Templates screen and both run workouts A and B above. Starting Strength is Mark Rippetoe’s program; IronLedger is not affiliated with him.

Starting Strength: load and go

Tap LOAD. Three sessions a week for four weeks, which then start again. Every lift starts from the empty bar (40 kg on the deadlift) unless you already have history for it, so change the first weights to yours on day one.

After that it recommends each next load from what you logged and shows the reason, using the rule written out here.

Starting Strength: set it up

Tap SET UP and pick your three days. It writes six weeks of sessions in advance, starting from the empty bar (40 kg on the deadlift) and adding the steps shown above every session; it does not adjust to what you log.

After six weeks it starts again from week one, back at the bar, so change the weights yourself or switch to the load-and-go version.

Where it differs

Both versions stay in the book’s first stage: no power cleans or chin-ups. They add one fixed step per lift instead of the book’s larger early jumps and smaller later ones, and have no rule for backing off after missed reps. Every working set is marked RIR 0, and warm-up notes are in kilograms even if you lift in pounds. These are known issues.

// DIRECT ANSWERS //

Questions lifters ask.

What is the Starting Strength program?

Mark Rippetoe’s novice barbell program, from his book Starting Strength: Basic Barbell Training (third edition, 2011). It is built on the squat, press, bench press, deadlift and power clean, with a few assistance exercises such as chin-ups. Two workouts alternate three days a week, and the weight goes up each session while you can keep recovering from it.

Is Starting Strength good for beginners?

It is written for them. Three days a week sits inside the American College of Sports Medicine’s range of 2 to 3 days for novices, though the ACSM suggests loads you can lift 8 to 12 times for beginners, where Starting Strength uses sets of 5. Heavier sets build more one-rep-max strength, per a 2017 meta-analysis, which is the program’s goal.

How much weight should I add each workout?

The book’s guide for most men: 10 lb on the squat each workout for two to three weeks, then 5 lb; 15 lb on the deadlift for a couple of weeks, then 5 lb; about 5 lb on the bench press, press and power clean. Younger, older and lighter lifters and most women start with smaller jumps and need plates lighter than 2.5 lb.

How long should I run Starting Strength?

The book says to stay with it for as many months as possible, adding weight every workout. When you miss the last rep or two on the squat, it says to back off 5 lb and carry on with 5 lb jumps. When even small jumps can no longer be kept up, you are an intermediate.

What comes after Starting Strength?

Rippetoe covers programming past the novice stage in a separate book, Practical Programming for Strength Training. Weekly programs such as the Texas Method and 5/3/1 are common next steps; our comparison of Starting Strength and 5/3/1 covers when to switch.

Does IronLedger include power cleans and chin-ups?

Not yet. The book brings in the power clean after the first couple of weeks and chin-ups two or three weeks after that; IronLedger runs only the first stage, with the deadlift every workout. Add power cleans and chin-ups yourself when you reach those stages.

Does IronLedger set the weights for me?

In the load-and-go version, yes: it starts from the empty bar (40 kg on the deadlift) unless you already have history, then recommends each next load from what you logged. The version you set up writes every session’s weight in advance, starting from the bar and adding a fixed step each time.

How the next load is chosen

On the load-and-go programs, every recommended load comes with where it came from and the reason. The rule is written down in full, with examples.

Read the rule

// KEEP READING //

Related reading.

Starting Strength vs 5/3/1

Which to run next, and when a novice program has run its course.

When linear progression stops

How to tell a real stall from a bad week, and what to change.

Push Pull Legs

Push, pull and legs on separate days, six days a week: all six workouts, with sets, reps and effort.

Arnold Split

Chest with back, shoulders with arms, then legs, twice a week: all three workouts, with supersets and pyramids.

Upper Lower Split

Upper body one day, lower body the next, four days a week: all four workouts, with sets, reps and effort.

PHUL

Brandon Campbell’s Power Hypertrophy Upper Lower: two heavy days and two size days a week, all four workouts, and how PHUL differs from PHAT.

Mike Mentzer Heavy Duty

Mentzer’s high-intensity routine in his own words: two workouts every other day, a few sets to failure, pre-exhaust pairs.

Powerbuilding

Strength and size in one plan: heavy sets on the big lifts plus volume for growth, and three free programs built on it.

Dorian Yates Blood & Guts

Yates’s high-intensity method in his own words: two warm-up sets, then one all-out set to failure, on a four-day split.

StrongLifts 5x5

Two alternating full-body workouts, 5 sets of 5, three days a week, with a little more weight each time.

Greyskull LP

Johnny Pain’s linear progression: 2 sets of 5 and a set to failure, small jumps, and a planned reset when a lift stalls.

Madcow 5x5

The intermediate 5x5: medium, light and heavy days, sets that climb to a top set, and a new top set each week.

Texas Method

Volume Monday, light Wednesday, a new 5-rep max on Friday: the weekly program for lifters past novice gains.

GZCLP

Cody Lefever’s three-tier linear progression for newer lifters, with its built-in plan for stalls.

nSuns 5/3/1 LP

High-volume 5/3/1-style training, nine top sets and back-off sets a day, with a weekly training max increase.

Smolov and Smolov Jr

A squat specialisation block of about 13 weeks, and its three-week short version, from your max.

Sheiko Beginner

Three days a week of squat, bench press and deadlift at moderate percentages of your max, in preparation and competition blocks.